V3.0 Update

refactor(board): Update to z3.2

Major update to underlying code requires change to the repo, brought in line with zmk pr for commonality, fixed indentation to comply with zmk pre-commit formatting reqs

Update settings-reset, change RGB modes

Add Update instructions, Assets folder

config/boards/arm/adv360/adv360_right_defconfig

@@ -1,14 +1,11 @@
 #
-# Copyright (c) 2021 Polarity Works
+# Copyright (c) 2022 The ZMK Contributors
 # SPDX-License-Identifier: MIT
 #
 
 CONFIG_SOC_SERIES_NRF52X=y
 CONFIG_SOC_NRF52840_QIAA=y
 CONFIG_BOARD_ADV360_RIGHT=y
-CONFIG_ZMK_BLE=y
-CONFIG_ZMK_SPLIT=y
-
 
 # Enable MPU
 CONFIG_ARM_MPU=y
@@ -16,9 +13,8 @@ CONFIG_ARM_MPU=y
 # enable GPIO
 CONFIG_GPIO=y
 
-
-
-# Enable SPI
+# Enable SPI for LEDS
+CONFIG_PINCTRL=y
 CONFIG_SPI=y
 CONFIG_SPI_NRFX=y
 
@@ -33,27 +29,28 @@ CONFIG_FLASH_MAP=y
 
 # Enable 32kHz crystal
 CONFIG_CLOCK_CONTROL_NRF_K32SRC_XTAL=y
-CONFIG_CLOCK_CONTROL_NRF_K32SRC_500PPM=y
+CONFIG_CLOCK_CONTROL_NRF_K32SRC_150PPM=y
 
+#RGB leds config
+CONFIG_WS2812_STRIP=y
 CONFIG_ZMK_RGB_UNDERGLOW=y
 CONFIG_ZMK_RGB_UNDERGLOW_EXT_POWER=y
 CONFIG_ZMK_RGB_UNDERGLOW_ON_START=y
 CONFIG_ZMK_RGB_UNDERGLOW_EFF_START=4
 CONFIG_ZMK_RGB_UNDERGLOW_AUTO_OFF_IDLE=y
 
-# Use the STRIP config specific to the LEDs you're using
-CONFIG_WS2812_STRIP=y
-CONFIG_BT_CTLR_TX_PWR_PLUS_8=y
+#Backlighting configuration
 CONFIG_PWM=y
 CONFIG_LED_PWM=y
 CONFIG_ZMK_BACKLIGHT=y
+CONFIG_ZMK_BACKLIGHT_BRT_START=20
 CONFIG_ZMK_BACKLIGHT_AUTO_OFF_IDLE=y
 
-CONFIG_ZMK_HID_REPORT_TYPE_NKRO=y
-CONFIG_ZMK_HID_CONSUMER_REPORT_USAGES_BASIC=y
-
+#Misc configuration
 CONFIG_USB_DEVICE_VID=0x29EA
 CONFIG_USB_DEVICE_PID=0x0362
 CONFIG_USB_DEVICE_MANUFACTURER="Kinesis Corporation"
-
+CONFIG_BT_CTLR_TX_PWR_PLUS_8=y
+CONFIG_ZMK_HID_REPORT_TYPE_NKRO=y
+CONFIG_ZMK_HID_CONSUMER_REPORT_USAGES_BASIC=y
 CONFIG_BUILD_OUTPUT_UF2=y